A List of Abbreviations
Appendix
A-2 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
DIN Deutsche Industrie Norm (German Industry Standard)
DIO Data Input/Output: Data transfer display
DIR DIRectory Directory
DITE DIsplacement Thread End
DITS DIsplacement Thread Start
DOE Data Communication Equipment
DPM Dual-Port Memory
DPR Dual-Port RAM
DRF Differential Resolver Function: (handwheel)
DRY Dry run feedrate
DSB Decoding Single Block
DSC Dynamic Servo Control / Dynamic Stiffness Control
DSR Data Set Ready
DTE Data Terminal Equipment
DTR Data Terminal Ready
EIA code Special punched tape code, number of holes per character always odd
ENC ENCoder: Actual-value sensor
EPROM Erasable Programmable Read-Only Memory
ERROR ERROR from printer
ESR Extended Stop and Retract Function
FB Function Block
FC Function Call: Function block on the PLC
FD Feed Drive
FIFO First In First Out: memory, which works without address specification and whose
data are read in the order in which they were stored.
FIPO Fine InterPOlator
FOC Force Control
FST Feed STop
GEO Geometry
GIA Gear Interpolation dAta
GND Signal GrouND
GS Gear Step
GSC Gear Step Change
GUD Global User Data
GWPS Grinding wheel peripheral speed
HASH A software method for mapping a large number of names onto a finite memory area
HEX Abbreviation for hexadecimal number
HMI Human Machine Interface: Operator function of SINUMERIK for operation,
programming and simulation. HMI means the same as MMC.
HW Hardware
I/R Infeed/regenerative feedback unit of SIMODRIVE 611(D)
IC (GD) Implicit Communication (Global Data)
ICA Interpolatory Interpolatory compensation
To Next Page
Loading...
Need help?
General
