Brief Description
1.1 Function
Diagnostic Tools (D1)
1-2 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
External diagnostic tools
The 611D startup software (to be installed on an external computer) is used to configure and
set parameters for SIMODRIVE 611-D drives.
The 611D startup software provides the following functions:
• Initial startup through direct input of drive parameters
• Startup by transferring standard data records that are derived from motor/power section
combinations
• Automatic controller setting (self-optimization)
• Measurement functions for evaluating speed and position control loops and regulating
torque in the time and frequency range without external measurement equipment.
• Fast Fourier Transformation (FFT) for analysis of the control loop setting and machine
kinematics
• Circularity test
• Archiving drive and control data
By means of the DAC configuration, the 611D drive modules enable the output of all
important control loop variables of the position, speed and torque levels to external
measurement devices (e.g. oscilloscope, signal plotter) via measuring sockets.
References
A detailed description of the 611D startup software can be found in:
/FBA/ functional description of drive functions, speed control loop (DD2)
A detailed description of the circuit test can be found in:
/FB/ functional description of extended functions, compensations (K3)
To Next Page
Loading...
Need help?
General
