EasyManuals Logo

Siemens SINUMERIK ONE MCP 2400.4c Function Manual

Siemens SINUMERIK ONE MCP 2400.4c
2050 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #349 background imageLoading...
Page #349 background image
Detailed Description
2.2 Travel to fixed stop with analog drives
Travel to Fixed Stop (F1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-25
Enabling the fixed stop alarms
The machine parameter:
MD37050 FIXED_STOP_ALARM_MASK
can be used to set the enabling of the fixed stop alarms as follows:
MD 37050 = 0 Fixed stop not reached (suppress Alarm 20091)
MD 37050 = 2 Fixed stop not reached ( suppress alarm 20091) and
fixed stop aborted (suppress alarm 20094)
MD 37050 = 3 Fixed stop aborted (suppress alarm 20094)
All other permissible values of 7 or less do not suppress any alarms.
Using the parts program command NEWCONF a new setting can be activated.
Terminal 663 with MD37002 controllable
With the machine parameter:
MD37002 FIXED_STOP_CONTROL
the response to pulse blocking on the fixed stop is controllable.
Deleting the pulses by terminal 663 or the IS "Pulse enable" DBX31, ...DBX21.7 will not
abort the function. As a result, the drive will press against the fixed stop again without any
further operating action when the machine is restarted.
The rise time of the torque corresponds to the time needed by the current controller of the
drive to reach the limitation again.
If the pulses are deleted when a deselection is active (waiting for PLC acknowledgments),
the torque limit will be reduced to zero. If the pulses are reactivated during this phase, torque
is no longer built up. Once the deselection has been completed, you can continue traversing
as normally.

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals