To Next Page

To Previous Page

Contents

Auxiliary Function Output to PLC (H2)

iv Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0

3 Supplementary conditions....................................................................................................................... 3-1

3.1 General constraints .................................................................................................................... 3-1

3.2 Output behavior.......................................................................................................................... 3-2

4 Examples................................................................................................................................................ 4-1

4.1 Defining auxiliary functions ........................................................................................................ 4-1

5 Data Lists................................................................................................................................................ 5-1

5.1 Machine data.............................................................................................................................. 5-1

5.1.1 NC-specific machine data .......................................................................................................... 5-1

5.1.2 Channel-specific machine data.................................................................................................. 5-1

5.2 Signals........................................................................................................................................ 5-2

5.2.1 Signals to channel...................................................................................................................... 5-2

5.2.2 Signals from channel.................................................................................................................. 5-2

5.2.3 Signals to axis/spindle................................................................................................................ 5-4

5.2.4 Signals from axis/spindle ........................................................................................................... 5-5

Index................................................................................................................................................ Index-1