Detailed Description
2.4 Frames
Axis Types, Coordinate Systems, Frames (K2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-73
Example:
Machine data for TRANSMIT
; FRAME configurations
$MC_MM_SYSTEM_FRAME_MASK = 'H41' ; TRAFRAME, SETFRAME
$MC_CHSFRAME_RESET_MASK = 'H41' ; Frames are active after Reset
$MC_CHSFRAME_POWERON_MASK = 'H41' ; Frames are deleted on POWER ON
$MN_FRAME_GEOAX_CHANGE_MODE = 1 ; Frames are calculated after switchover of
the geo axis
$MC_RESET_MODE_MASK = 'H4041' ; Basic frame is not deselected after RESET
;$MC_RESET_MODE_MASK = 'H41' ; Basic frame is deselected after RESET
;$MC_GCODE_RESET_VALUES[7] = 2 ; G54 is the default setting
$MC_GCODE_RESET_VALUES[7] = 1 ; G500 is the default setting
$MN_MM_NUM_GLOBAL_USER_FRAMES = 0
$MN_MM_NUM_GLOBAL_BASE_FRAMES = 3
$MC_MM_NUM_USER_FRAMES = 10 ; From 5 to 100
$MC_MM_NUM_BASE_FRAMES = 3 ; From 0 to 8
$MN_NCBFRAME_RESET_MASK = 'HFF'
$MC_CHBFRAME_RESET_MASK = 'HFF'
$MN_MIRROR_REF_AX = 0 ; No scaling when mirroring
$MN_MIRROR_TOGGLE = 0
$MN_MM_FRAME_FINE_TRANS = 1 ; Fine offset
$MC_FRAME_ADD_COMPONENTS = TRUE ; G58, G59 is possible
; TRANSMIT is 1st transformer
$MC_TRAFO_TYPE_1 = 256
$MC_TRAFO_AXES_IN_1[0] = 1
$MC_TRAFO_AXES_IN_1[1] = 6
$MC_TRAFO_AXES_IN_1[2] = 3
$MC_TRAFO_AXES_IN_1[3] = 0
$MC_TRAFO_AXES_IN_1[4] = 0
$MA_ROT_IS_MODULO[AX6] = TRUE;
To Next Page
Loading...
Need help?
General
