'(& )( )'& &) ( &!& ")& &$(( $# Ċ %&( $# #)" &&#$
I
page
IV
Siemens AG ⋅ May 1998
5.2.2.4 Cubicle version of the master unit 5 - 3..................................................
5.2.3 Check of the nominal data 5 - 4........................................................
5.2.4 Matching of the control voltage for the binary inputs 5 - 4.................................
5.2.5 Coding of the ZPS modules 5 - 7.......................................................
5.2.6 Checking the connections 5 - 8.........................................................
5.3 Configuration examples 5 - 9...........................................................
5.4 Marshalling possibilities 5 - 12..........................................................
6.1 Setting the master unit 6 - 1...........................................................
6.1.1 Integrated keypad/display panel 6 - 1....................................................
6.1.2 Communication software DIGSI 6 - 2...................................................
6.1.3 Operating pre-requisites 6 - 2..........................................................
6.2 Setting the protection 6-3............................................................
6.2.1 Introduction 6-3.....................................................................
6.2.2 Initial displays - blocks 00 and 01 6 - 4..................................................
6.2.3 Station lay-out data 6-4..............................................................
6.2.3.1 Reading-out of design data 6 - 4.......................................................
6.2.3.2 Changing of station data 6 - 4..........................................................
6.2.3.3 Station configuration - block 01 6 - 5....................................................
6.2.3.4 Common data station configuration - block 54 6 - 8.......................................
6.2.3.5 Configuration of the busbar - block 49 6 - 9..............................................
6.2.3.6 System data 6-10.....................................................................
6.2.4 Settings 6-12........................................................................
6.2.4.1 Settings for the busbar differential protection 6 - 12........................................
6.2.4.1.1 Settings for the pick-up characteristic - block 61 6 - 12.....................................
6.2.4.1.2 Settings for the differential current supervision - block 63 6 - 14.............................
6.2.4.2 Settings for the circuit breaker failure protection - blocks 62, 66 and 67 6 - 15.................
6.2.4.3 Settings for the supervisory functions - block 63 6 - 17.....................................
6.2.4.3.1 Settings for breaker failure protection supervision 6 - 17....................................
6.2.4.3.2 Settings for isolator supervision 6 - 18....................................................
6.2.4.3.3 Settings for linearized current transformers 6 - 18.........................................
6.2.4.3.4 Settings for protection and circuit breaker test 6 - 19.......................................
6.2.4.4 Settings for the overcurrent release of the TRIP command - block 65 6 - 19..................
6.2.5 Operational control features 6 - 20.......................................................
To Next Page
Loading...
