'(& )( )'& &) ( &!& ")& &$(( $# Ć %&( $# #)" &&#$
6 - 43
Siemens AG ⋅ May 1998
6.4.2.5 Marshalling of the command relays -
block 64
The bay unit contains 5 command relays, which are
designated by COMMAND RELAY 1 to 5. Several
functions can be marshalled to one command relay. In
the same way it is possible to marshall each logical
function to more than one command relay. The funcĆ
tions listed in table 6.8 can be marshalled to the comĆ
mand relays, too. The command relays are in the first
place determined for TRIP commands and transfer
trip signals. Depending on the station configuration
and the requirements they may, however, also be
used as additional alarm relays.
The pre-set functions upon delivery of the devices
are summarized in table 6.10.
Y
B
6 4 0 0 J M A R S H A L L I N G
T R I P R E L A Y S
Start of the block "marshalling of the command reĆ
lays"
"
A
6 4 0 1 J T R I P
R E L A Y 1
Marshalling for command relay 1
Depressing the "ENTER"-key opens the change
mode. Password is required.
"
A
1 J T R I P R E L . 1
C B F T r i p L 1
4 functions are pre-selected for command relay 1.
D (FNo 7051/FE) Trip command by circuit breaker
failure protection for phase L1
"
A
2 J T R I P R E L . 1
B B T r i p L 1 2 3
D (FNo 7040/FE) Trip command by busbar protection
three-phase
"
A
3 J T R I P R E L . 1
C B F T r i p L 1 2 3
D (FNo 7050/FE) Three-phase trip command by cirĆ
cuit breaker failure protection function
"
A
4 J T R I P R E L . 1
C B T e s t L 1
D (FNo 7060/FE) Trip command to circuit breaker in
phase L1 issued by the test function
"
A
5 J T R I P R E L . 1
n o t a l l o c a t e d
D no further command functions for command
relay 1
Exit from the change mode by depressing key
"ESC".
In the same manner, display and modification of the
pre-set allocation for command relays 2 to 5 can be
done after selecting the appropriate address.
To Next Page
Loading...
Need help?
General
