Siemens SIPROTEC 7SS52 - Page 11

 '(& )( )'& &) ( &!&  ")& &$(( $#   Ċ %&( $# #)" &&#$ 

I
page
V
Siemens AG ⋅ May 1998
6.2.5.1 Binary inputs 6-20....................................................................
6.2.5.2 Taking bays out of service - block 64 6 - 21...............................................
6.2.5.3 Test and control functions 6 - 21.........................................................
6.2.6 Alarms 6-24.........................................................................
6.2.6.1 Introduction 6-24.....................................................................
6.2.6.2 Marshalling of binary outputs and LED-indications 6 - 25...................................
6.2.7 Operational event recording - block 71 6 - 28.............................................
6.2.8 Measured values for commissioning - blocks 74, 75, 76, 78 6 - 30...........................
6.2.9 Fault events- block 72 6 - 32............................................................
6.3 Operating the bay unit 6 - 33............................................................
6.3.1 Keypad/display 6-33..................................................................
6.3.2 Prerequisite and language for operation 6 - 34.............................................
6.4 Device settings 6-36..................................................................
6.4.1 Settings via the integrated operation - block 71 6 - 36......................................
6.4.2 Marshalling of binary inputs, binary outputs and LED indications 6 - 37.......................
6.4.2.1 Introduction 6-37.....................................................................
6.4.2.2 Marshalling of the binary inputs - block 61 6 - 37..........................................
6.4.2.3 Marshalling of the alarm relay - block 62 6 - 40............................................
6.4.2.4 Marshalling of the LED indications - block 63 6 - 41........................................
6.4.2.5 Marshalling of the command relays - block 64 6 - 43.......................................
6.4.2.6 Setting of function parameters - block 11 6 - 44...........................................
6.4.3 Test and control function - block 40 6 - 45................................................
6.4.4 Read out of operational measured values - block 57 6 - 46..................................
6.5 Testing and commissioning 6 - 48.......................................................
6.5.1 General 6-48.........................................................................
6.5.2 Testing the pick-up values of the busbar protection 6 - 49..................................
6.5.2.1 Test set-up 6-49.....................................................................
6.5.2.2 Bus-zone specific protection 6 - 49......................................................
6.5.2.3 Check zone 6-51.....................................................................
6.5.3 Checking the differential current limit for differential current supervision 6 - 52................
6.5.3.1 Test set-up 6-52.....................................................................
6.5.3.2 Bus-section specific protection 6 - 52....................................................
6.5.3.3 Check zone 6-53.....................................................................
6.5.4 Testing the pick-up values for controlled tripping 6 - 53.....................................
6.5.4.1 Test set-up 6-53.....................................................................
www . ElectricalPartManuals . com