'(& )( )'& &) ( &!& ")& &$(( $# Ċ %&( $# #)" &&#$
I
page
IX
Siemens AG ⋅ May 1998
Figure 6.4 Pick-up characteristic of busbar protection 6 - 52.......................................
Figure 6.5 Test set-up for checking the characteristic of the circuit-breaker
failure protection function 6 - 54......................................................
Figure 6.6 Test set-up for unbalance time measurement 6 - 55....................................
Figure 7.1 Location of the fine-wire fuse in the power supply module SAF of the bay unit 7 - 4.......
Figure 7.2 Location of the fine-wire fuse in the power supply module SV of the master unit 7 - 4.....
Figure 7.3 Components for data transmission 7 - 10..............................................
Figure 7.4 Connection of the interface points for
the test run 7-11..................................................................
Figure 7.5 Location of jumpers on the module PFE of the
bay unit 7-11......................................................................
Figure A.9.1 Short-circuit on a feeder with CT saturation A - 11......................................
Figure A.9.2 Current/time characteristic A - 11.....................................................
Figure A.9.3 Connection diagram bay unit A - 12...................................................
Figure A.9.4 Connection diagram Master Unit A - 13...............................................
Figure A.9.5 Connection diagram Master Unit (Cont.) A - 14.........................................
Table 1.1 Data for selection and ordering 1 - 2.................................................
Table 2.1 Overview of the device connections 2 - 10.............................................
Table 3.1 General device data 3 - 1...........................................................
Table 3.2 Electrical tests 3-3...............................................................
Table 3.3 Mechanical tests 3-4.............................................................
Table 3.4 Climatic conditions 3 - 4...........................................................
Table 3.5 Busbar protection 3-5.............................................................
Table 3.6 Circuit-breaker failure protection 3 - 6................................................
Table 3.7 General data 3-6.................................................................
Table 3.8 Ancillary functions 3-7.............................................................
Table 4.1 Isolator status indications 4 - 13......................................................
Table 4.2 Allocation of a feeder to a busbar section 4 - 15........................................
Table 4.3 Summary of the monitoring functions 4 - 37............................................
Table 5.1 Control voltage for the binary inputs on the EFE (bay unit) in relation to the fitted jumper 5 - 4
Table 5.2 Control voltage for the binary inputs on the EAZ1 (master unit) in relation
to the fitted jumper 5 - 4............................................................
To Next Page
Loading...
Need help?
General
