'(& )( )'& &) ( &!& ")& &$(( $# Ċ %&( $# #)" &&#$
I
page
X
Siemens AG ⋅ May 1998
Table 5.3 Binary inputs and outputs 5 - 12......................................................
Table 6.1 Allocation of the binary inputs 6 - 20..................................................
Table 6.2 List of the available collective alarms 6 - 24............................................
Table 6.3 Preset LEDs and alarm relays 6 - 26...................................................
Table 6.4 Isolator events (changes of status; failures) 6 - 28.......................................
Table 6.5 Supervisory events 6 - 28............................................................
Table 6.6 Collective alarms "Failure with/without protection block" 6 - 30..........................
Table 6.7 Fault events 6-32..................................................................
Table 6.8 Marshallable binary input functions 6 - 39..............................................
Table 6.9 Pre-set binary inputs 6 - 39..........................................................
Table 6.10 Marshallable output functions 6 - 40..................................................
Table 6.11 Pre-set LED indications 6 - 42........................................................
Table 6.12 Pre-set command relay functions 6 - 44...............................................
Table 7.1 ZPS-SBK 7-5....................................................................
Table 7.2 ZPS-BSZ 7-5.....................................................................
Table 7.3 ZPS-SK 7-5......................................................................
Table 7.4 Power supply module of the master unit 7 - 6.........................................
Table 7.5 Status events 7-8.................................................................
Table 7.6 ZPS-SK 7-10......................................................................
Table A.9.1 Alarms from the master unit for PC, LC display and binary inputs and outputs A - 4........
Table A.9.2 Basic position of jumpers on ZPS-module (master unit) A - 15............................
Table A.9.3 Basic position of switches on ZPS-module (master unit) A - 15...........................
Table A.9.4 Basic position of switches on EAZ-modules A - 16......................................
Table A.9.5 Pre-setting of annunciation relays and LED's of master unit A - 17........................
Table A.9.6 Pre-settings of binary inputs of master unit A - 18......................................
Table A.9.7 Pre-settings of output relays of bay unit A - 18.........................................
Table A.9.8 Pre-set LED indications A - 19........................................................
Table A.9.9 Pre-set binary inputs A - 19..........................................................
Table A.9.10 Marshallable output functions A - 20..................................................
To Next Page
Loading...
