'(&)( )'&&)( & & !)& &$(($# * %&($# "#)! &&#$
⋅
6300 SETTINGS: Supervision ?
6301 ISO TRA TIM =7.00 s (min. 1.00 – max. 180.00)
6302 ISO MAL RES =alarm only
1)
(alarm only, blockAutoReleas,
block storage)
6303 DIFF SUPERV =active (inactive, active)
6304 T–DIFF SUPV =2 s (min. 1 – max. 10 )
6305 I>SUPERV:BZ =.10 I/Ino
2)
(min. 0.05 – max. 0.80)
6306 I>SUPERV:CZ =.10 I/Ino
2)
(min. 0.05 – max. 0.80)
6307 DIFF SUP BZ =alarm only (alarm only, blockAutoReleas,
block storage)
6308 DIFF SUP CZ =alarm only (alarm only, blockAutoReleas,
block storage)
6309 ZERO CR SUP =active (inactive, active)
6310 I> ZERO CR =.50 I/Ino
2)
(min. 0.20 – max. 4.00)
6311 AUTO TEST =active (inactive, active)
6312 TEST FAULT =alarm only (alarm only, block protect.)
6313 I< MAN TRIP =.05 I/IN
3)
(min. 0.00 – max. 0.50)
6314 MON T BF CI =1.00 s (min. 0.02 – max. 10.00)
6315 FLT T BF CI =.06 s (min. 0.06 – max. 1.00)
6316 FLTREC RELE =automatic (automatic, manual)
4)
6317 RELE BOS BU =released (blocked,released)
_______________
For supervision of run time, breaker fault and auxiliary voltage
Ino – Normalized nominal current related to base current transformer (current transformer with
highest transformation ratio)
IN – Nominal current of bay current transformer
Two fault record buffers, each 300 ms(200 ms before and 100 ms after the fault) are available.
Release auto: The fault record is automatically switched over to the other memory after each
end of a fault. A previous fault record, still existing there, is overwritten.
Release manual: After storing two fault records, the fault recording function remains blocked
until released via operation in DA 8300. If released, then both buffers are erased, independent
of their contents.
To Next Page
Loading...
