To Next PageTo Next PageWhat to do if Siemens SITRANS T Transmitter shows maximum supply voltage exceeded?
If the Siemens Transmitter detects that it is operated above its specified supply voltage range, check the power supply at the output terminals.
How to resolve a process value tolerance issue on a Siemens SITRANS T Transmitter?
If at least one process value violates one of the process tolerance limits set in the Siemens Transmitter parameters, check the parameter settings for limits for this application.
How to fix an error in communication with input CPU on a Siemens SITRANS T?
If the Siemens Transmitter experiences an unrecoverable error in the internal communication to the input CPU, reset the device or switch it off and back on.
How to resolve an input CPU reconfiguration failure on a Siemens SITRANS T?
If the Siemens Transmitter experiences an unrecoverable error in the input CPU, reset the device or switch it off and back on.
What to do if Siemens SITRANS T Transmitter has electronics defect?
If there is a defect in the Siemens Transmitter electronics, a replacement of the device is recommended.
General| Model | SITRANS T Series |
|---|---|
| Type | Temperature Transmitter |
| Measurement Principle | Resistance variation with temperature (RTD), Voltage generation with temperature difference (Thermocouple) |
| Input | RTD, Thermocouple, Resistance, Millivolt |
| Input Range | Depends on sensor type (e.g., Pt100: -200°C to +850°C) |
| Measurement Range | Varies depending on the specific model and sensor type, Corresponds to the input range |
| Output Signal | 4 to 20 mA, HART (depending on model) |
| Accuracy | ±0.1% of span (typical) |
| Ambient Temperature | -40°C to +85°C (-40°F to +185°F) |
| Housing material | Plastic or aluminum |
| Protection Class | IP66, IP67 |
| Sensor Types | RTD (Pt100, Pt200, Pt500, Pt1000, Ni100, Cu10) or TC (Type J, K, N, E, R, S, B, T, C, L) |
| Communication Protocol | HART |
