Communication
11.23 DR 30 Process state
SIWAREX WT241
156 Manual, 05/2015, A5E36046748A
11.23.2 Current belt load
The current material weight of the loaded belt acting on one unit of the weigh length.
11.23.3 Current belt load in %
Current belt load in % of nominal belt load
11.23.4 Current flow rate
The current material flow rate (belt load x speed).
11.23.5 Current flow rate in %
The current material flow rate (belt load x speed) in % of the nominal flow rate.
11.23.6 Current speed
The current speed used to calculate the material flow rate. The output is made as length per
second.
11.23.7 Current speed in %
The current speed used to calculate the material flow rate. The output is made in % of the
maximum speed.
11.23.8 Current master totalizer (S1)
The total material flow is summed after the start-up and switching-off of service mode.
Resetting the total is only possible using the "Load factory settings" command.
11.23.9 Current main totalizer (S2)
The material flow is saved in a powerfail-proof memory. It can be deleted using the "Log and
delete" command.
To Next Page
Loading...
