Messages
9.3 Message list
SIWAREX WT241
Manual, 05/2015, A5E36046748A 83
9.3 Message list
The message list is an overview of all messages that the SIWAREX module can generate. A
message can be quickly identified by the message code (number).
9.3.1 System status message list
Operating errors (code 1000 to 1999)
sorted by code no.
1000 operating error exists
Group message, at least one operating error exists.
Watchdog, error is displayed for at least 10 seconds. A seri-
ous error has occurred in the function of SIWAREX, e.g.
program error, severe electromagnetic influence on device,
etc.
Contact the SIWAREX Support if the error occurs multiple
times.
RAM error. An error has occurred in the memory; the memory
content is no longer correct. The module must be switched
off. If the error occurs again, SIWAREX is defective.
1003 Checksum incorrect parameter
Checksum error at parameter. Critical error because the
parameters are no longer safe.
1004 Checksum incorrect program
Checksum error program code. Critical error because the
program is no longer safe.
Error when writing/deleting,or logbook full
AD converter error when reading in the measured value. If
the error occurs again, make sure that the EMC recommen-
dations are observed (chapter EMC-compliant setup
(Page 20)).
Undervoltage at sensor cables
Overload of scale (ca. 110%)
Underload of scale (ca. -10%)
1107 Legal trade display failure
The SecureDisplay legal trade display no longer communi-
cates with the module
9.3.2 Technology error message list
Technology error (code 2000 to 4999)
Group message, at least one technology error exists
The set recording rate for trace function cannot be processed. Set
a slower recording rate.
The zeroing procedure has been canceled. Possible causes:
violation of zeroing limits.
The trace recording has been cancelled. Possible causes: trace
memory full and not declared as ring memory.
To Next Page
Loading...
