Scale parameters and functions of the belt scale
8.8 Menu 1.6 Recovery / reset
SIWAREX WT241
72 Manual, 05/2015, A5E36046748A
Belt speed simu-
lation value
Enter the belt speed value to be simulated.
8.8 Menu 1.6 Recovery / reset
Setting the recovery point in this menu creates an image of all settings of the weighing proces-
sor. Reloading is possible anytime and will overwrite the current settings.
Creates an image of all settings. Execution will not be acknowledged.
Loads the latest created image. Execution will not be acknowledged.
Load standard
scale parameter
Like "Load factory settings", but interface settings for Ethernet and Mod-
bus RTU are not reset to the factory setting.
The command resets the SIWAREX to the "ex works" status. During this
process:
- all parameters and saved data (including protocol memory and logbook)
as well as the restore point are loaded with the default values
- all message buffers (diagnostics buffer, trace memory, etc.) are reset
8.9 Menu 2.1 Messages
Opens the message log of the weighing electronic.
To Next Page
Loading...
