Siemens SIWAREX WT241 - Totalizer 3 (S3), Totalizer 4 (S4), Totalizer 5 (S5); Totalizer 6 (S6)

Communication
11.26 DR 33 Totalizers
SIWAREX WT241
Manual, 05/2015, A5E36046748Aa 165
11.26.3 Totalizer 3 (S3), totalizer 4 (S4), totalizer 5 (S5)
The totalizers respond like the main totalizer S2. In the case of trade scales requiring
verification, these totals can be reset without logging.
You can reset the totals individually to 0 using the following commands:
● S3 using command 671
● S4 using command 672
● S5 using command 673
11.26.4 Totalizer 6 (S6)
A special property of totalizer 6 is that it remains active even following the command "Stop
totalizing (652)", and therefore indicates the total amount. You can therefore carry out
material tests or calibrate the scale, for example, without recording the "transported material"
(calibration weight, test chain) into the balance.
You can reset the total S6 using command 674.