Siemens SIWAREX WT241 - Page 85

Messages
9.3 Message list
SIWAREX WT241
Manual, 05/2015, A5E36046748A 85
Data and operating errors
(code 5000 to 8999)
Error code
Description and remedy
7004 Assignment of DIs/DQs incorrect
7004
An error occurred while assigning the digital inputs or digital
outputs.
7006 Reserved
7006
Reserved
7007 The calibration weights or calibration
digits are not plausible
7007
Specifications for calibration weights or digits in data record
DR 3 are incorrect (minimum distance, reversal of incline).
7008 Zeroing parameters are not plausible
7008
The specifications for zeroing (data record DR 3) are not
plausible.
7010 Scale interval / rounding
7010
Scale interval or selection for rounding to decimal places is
not plausible.
7011 Filter parameters
7011
Specification of filter parameters is not plausible.
7013 Interface assignment for calibratable
HMI not plausible
7013
The assignment of the interface to the calibratable HMI is
incorrect.
7014 Specified time not plausible
7014
Specified time value is not plausible or may be signaled in
connection with additional errors
7016 Parameter assignment of analog
output not plausible
7016
The parameters for the analog output (data record DR 7) are
not plausible.
7017 MAC address cannot be changed
7017
7018 Error in IP mask
7018
The specified IP addresses (DR12) are not plausible.
7019 RS485 parameter error
7019
The specified RS485 interface parameters (DR13) are not
plausible.
7020 Speed parameter or sensor parame-
ter not plausible
7020
The speed parameter or sensor parameter in DR3 is not
plausible.
7021 Units are not plausible
7021
The selected units are not plausible (mixing of metric and
imperial parameters).