3 System Controls
3 - 70 [ 1 ] I N S T R U C T I O N S F O R U S E
3D LCD Selections for Volume Viewing
At completion of volume acquisition or when reviewing a previously
acquired volume, you can access the 3D review LCD selections by rotating
the FUNCTION SELECT control on the LCD panel to highlight the MPR tab
on the LCD.
Note: The following LCD selections are also available before acquisition, from the 3D tab
of the LCD: Noise Cut, Penetration, Auto-Brightness.
LCD Selection Description Settings
|Contrast
Specifies the contrast level for the volume.
Note: This selection is also available on the
volume toolbar.
0 to 299, in increments of 5
|Noise Cut
Sets a threshold for information displayed in the
volume. Indicates the low threshold for the
opacity curve.
0 to 240, in increments of 5
|Brightness
Specifies the brightness level for the volume.
Note: This selection is also available on the
volume toolbar.
0 to 255, in increments of 5
|Penetration
Specifies the display depth for the volume. Indicates
the high threshold for the opacity curve.
Note: The system does not allow a value identical to or
lower than the Noise Cut setting.
1 to 255, in increments of 5
|Auto-Brightness
Automatically assigns optimal values for brightness
and contrast to the acquired 3D volume.
---
To Next Page
Loading...
