5 B e g inning a n E x a m in a t io n
[ 1 ] I N S T R U C T I O N S F O R U S E 5 - 1 9
Examination Completion
Printing a Patient Report
For exam types with a patient report, the system transfers labeled
measurements and calculations from a Measurement Menu on the image
screen to a report. You can print the report to an optionally installed video
printer using the control panel, or you can transfer the report to the USB or
RS-232C port by selecting the Send Report button on the report page.
Video Printer (On-board)
Use the system presets to assign a documentation control to the
printing function.
To print the report to an on-board video printer:
Press a documentation control on the control panel that is configured for
the print function.
The system transfers the information displayed on-screen to the
specified documentation device.
Peripheral Printer (Off-board)
Use the system presets to assign functionality to the serial port or to a USB
port as the destination for data sent through the system.
To send data to a USB port or the RS-232C port:
Roll the trackball to the Send Report button on the report and then
press the SET key on the control panel.
The Send Report button is changed to the Cancel button.
To cancel the Send Report command:
To interrupt immediately, roll the trackball to the Cancel button and then
press the SET key.
To stop after the current page, press the ESCAPE key.
System Reference
System Presets Ch 3
Printer Installation Ch 5
F4
System Configuration
ŹPeripheral
ŹŹRS-232
ŹŹUSB
ŹCustomize Keys
ŹStorage
To Next Page
Loading...
