Siemens SONOLINE G50 - Measurements, Calculations, and Reports; General Functions; General 2 D-Mode Measurements and Calculations

6 T e chnical Description
6 - 12 [ 1 ] I N S T R U C T I O N S F O R U S E
Measurements, Calculations,
and Reports
Two categories of measurements and calculations are available on the
ultrasound system: general and exam-specific.
General Functions
 2D-mode and M-mode imaging have up to eight (8) distance sets of
caliper measurements per image
Area and circumference: up to eight Ellipse, Trace, Spline, and Cross
measurements per image
 Doppler has up to eight (8) points available on the waveform display
 Ratio Calculations
General 2D-Mode Measurements and Calculations
 Angle
 Distance/Depth
 Circumference (using a Trace, Ellipse, Spline, or Cross method)
 Area (using a Trace, Ellipse, Spline, or Cross method)
 Volume (using a 2-Plane Volume or a 1-Plane Volume)
 Residual Volume and Thyroid Volume
 Flow Volume (using an Area or Diameter method with a
Doppler measurement)
General M-Mode Measurements and Calculations
 Distance
 Time
 Heart Rate
 Slope
 Flow Volume (using a Diameter method with a Doppler measurement)
 Ratio Calculations