3 System Controls
3 - 12 [ 1 ] I N S T R U C T I O N S F O R U S E
Dual/Select
Activates Dual-mode, which displays two separately acquired images,
side-by-side.
The DUAL/SELECT control consists of a set of two keys. The left key
displays an image on the left side of the screen. The right key displays an
image on the right side of the screen. Use either key to initiate Dual-mode.
Only one image can be active at any one time. The active image is indicated
by the lighting intensity of the selected key and by the brightened active
image indicator that displays on the image screen.
The DUAL/SELECT control can be used to toggle the active image. Pressing
the left key activates the left image and freezes the right image. Pressing
the right key activates the right image and freezes the left image.
Note: The system displays a full screen image when the key for the active image is
pressed. The system restores the side-by-side display when this key is pressed again.
Most imaging parameters can be changed independently.
4B
(Requires software version 1.2 or higher)
Activates 4B-mode which displays four separately acquired 2D-mode images.
Only one image is active at a time. The active image is indicated by the
brightened active image indicator.
Pressing the 4B key displays the first image on the upper left side of the
screen. Pressing the FREEZE key freezes the active image and displays the
next image. A total of four images can be displayed. Press the 4B key
repeatedly to cycle through and activate images.
Most imaging parameters can be changed independently.
Dual/Select
Active Image
Indicator.
4B
To Next Page
Loading...
