Siemens SONOLINE G50 - Protocol Editor Dialog Box Stress Echo

3 S ystem C ontrols
[ 1 ] I N S T R U C T I O N S F O R U S E 3 - 61
Protocol Editor Dialog Box 
Stress Echo
Note: Phases are stages.
Protocol Editor Dialog
Box Selection
Description
Protocol Name
When the Load button is selected, displays the name of the
loaded protocol.
When the New button is selected, allows you to enter a new protocol name.
Phase
Description
When the Load button is selected, displays the name of the first phase (or
selected phase).
When the New button is selected, allows you to enter a new phase name.
continuous
1
When Yes is selected, designates the stage as continuous.
When No is selected, designates the stage as non-continuous.
Loops
When a phase is selected in the Phase list, allows you to select the number of
loops to be acquired for each view in the selected phase.
View
Standard Views
Lists the standard views available for selection to be included in the protocol.
The selected views are displayed for every phase in the protocol.
WMS model
1
Lists the WMS models available for selection to be used by default in
the protocol.
New
Clears the Protocol Name selection and allows you to create a new protocol.
Load
Displays the Select Protocol to load dialog box and then displays information
about the selected protocol within the Protocol Editor dialog box.
Save
Saves changes.
Delete
Removes the protocol from memory.
Quit
Exits the Protocol Editor dialog box.
1
Requires software version 2.0 or higher