5 B e g inning a n E x a m in a t io n
[ 1 ] I N S T R U C T I O N S F O R U S E 5 - 1 1
Using the DICOM Modality Worklist
Search Feature
For software versions 1.5 or higher (requires DIMAQ-IP support and the DICOM 3.0
connectivity option)
Use the Worklist feature to automatically enter patient data on the
New Patient Data form. Systems with the Worklist option installed and the
Worklist server configured display a Worklist button on the screen.
To register a new patient using the Worklist feature:
1. Press the F1 key on the keyboard to display the New Patient Data
form.
2. Enter any required patient information for the Worklist search.
3. Select the Worklist button to perform a Worklist search. The system
will perform the search using one of the following methods:
– If the system is configured to perform a streamlined search, it
begins searching for all procedures scheduled for the next 24 hours.
The system uses any data entered on the New Patient Data form.
– If the system is not configured to perform a streamlined search, the
system displays the Worklist Search screen. The system populates
the search screen with any data entered on the New Patient Data
form.
4. If a search screen is displayed, enter any additional search criteria. Press
the Tab key to access the next field.
Note: You are unable to enter search criteria or perform a search if Use Cache in the
Offline field is selected.
5. To cancel the search and display the previous screen, select Cancel.
6. To clear the entered search criteria, select Clear.
7. To begin the search from the Worklist Search screen, select Search.
The system displays the search results at the top of the Worklist
Search screen and activates the Scheduled Procedures field and the
Select button.
F4
DICOM
Ź Worklist Server
ŹŹ Streamlined Search
To Next Page
Loading...
