5 B e g inning a n E x a m in a t io n
5 - 10 [ 1 ] I N S T R U C T I O N S F O R U S E
4. Roll the trackball to highlight the row containing the patient information
and then press the SET key.
The system retrieves and displays the information in the Preview pane
at the bottom of the screen.
5. To transfer the information to the Patient Data form, select the OK
button. To cancel the transfer of information, select the Cancel button
to exit and redisplay the Patient Data form.
To delete a stored patient listing:
1. Press the F1 function key located on the keyboard to access the patient
data form.
2. Roll the trackball to the ID LIST button located at the bottom of the form
and then press the SET key.
3. Roll the trackball to highlight the row containing the patient listing and
then press the SET key.
4. Select the ID DELETE button.
5. To accept the change, select the OK button on the confirmation
message screen to exit and redisplay the Patient Data form.
6. To cancel the deletion, select the Cancel button on the confirmation
message screen to exit and redisplay the Patient Data form.
To retrieve existing patient information from the hard disk or inserted
CD for the patient data form:
(Requires software version 1.2 or higher)
Note: DIMAQ-IP is required for this procedure.
1. Press the REVIEW key on the control panel.
2. If the system displays the Image screen, select the Study Screen
button to display the Study screen.
3. Select the required disk from the Disk section of the Study screen to
display studies stored on the disk.
4. Select the required study and then select the New button.
The system displays the New Patient Data form containing the patient
information from the selected study.
To Next Page
Loading...
