Siemens SONOLINE G50 - General System Settings; Modifying Hospital or Clinic Name

4 S y stem Setup
[ 1 ] I N S T R U C T I O N S F O R U S E 4 - 3 1
General System Settings
You can change general system settings such as the on-screen display of
the date, time, and hospital name using the system presets. These settings
display on the image screen as well as on patient reports.
Note: If the setup menus are accessed when the system is in freeze, you must unfreeze
the system to display the changes.
Modifying Hospital or Clinic Name
To change the hospital or clinic name, enter a new name into the
system preset.
To change the hospital name:
1. Press the F4 key on the keyboard to access the system presets.
The system displays the Preset Main Menu screen.
2. Roll the trackball to General on the left of the screen and then press the
SET key on the control panel.
3. Roll the trackball to Hospital Name, and then press the SET key.
4. Enter a name and then press the SET key. You can enter up to
60 characters.
5. Roll the trackball to Save and then press the SET key to store the new
settings and exit the system presets.
System Reference
System Presets Ch 3

F4
General
ŹHospital Name