4 S y stem Setup
4 - 8 [ 1 ] I N S T R U C T I O N S F O R U S E
Prior to the Move
1. Power off ( ) the ultrasound system. The power (partial) on/off (
/
)
switch is located on the left front of the control panel.
2. Unplug the power cord from the wall outlet. Pull on the plug, not
the cord.
3. Secure the power cord to avoid rolling the system wheels over the cord.
4. To ensure that the transducers are transported safely, remove each
transducer and place it in its protective carrying case.
5. Push the keyboard under the control panel.
6. Disconnect off-board documentation devices from the system.
7. Transport gel, video tapes, and CD-R disks separately.
8. Disconnect the optional footswitch.
9. Release both the front and rear brakes.
During the Move
Caution: When moving the ultrasound system, protect it from environmental
changes including: moisture, winds, dirt and dust, and extreme heat or
cold exposure.
Caution: Avoid moving the ultrasound system on outside surfaces with loose
dirt, contaminates, or standing liquids.
Caution: Care should be taken to minimize shock and vibration of the
ultrasound system. Avoid uneven surfaces that contain an abrupt height change
or jarring surface irregularities.
You can move the ultrasound system from room to room within a facility
and easily reposition the system during an examination. Be careful on
inclines and uneven surfaces. The ultrasound system can be moved across
pavement and other hardened parking lot surfaces.
Note: The wheels of the ultrasound system must be locked when transporting by
vehicle. The ultrasound system must be sufficiently anchored to the vehicle floor or walls
such that it does not shift or move during transport.
[1] Instructions for Use
Power Off 4-12
Transducer Care Ch 2
To Next Page
Loading...
