4 S y stem Setup
4 - 10 [ 1 ] I N S T R U C T I O N S F O R U S E
System Startup
The first step to operating the ultrasound system is to connect the system
to a power source.
Plugging in the System
The ultrasound system has a detachable power cord. Ensure that the
power cord is connected to the system before connecting the cord to the
power source.
WARNING: For 115V units only: to ensure grounding reliability, connect the
system only to a hospital-grade power receptacle.
To plug in the system:
Connect the power cord to the MAINS supply as follows:
– 230V systems to a 230V standard mains, i.e. "Schuko" receptacle
(CEE 7-7 standard).
Example of power panel, 230V.
1 Equipotential
connector
2 Power cord
connector
3 MAINS circuit
breaker
I = on
{
= off
To Next Page
Loading...
