TC35i AT Command Set
8.9 AT^SALS
s
m
obil
e
TC35i_ATC_V02.07 Page 206 of 439 1/30/04
Confidential / Released
The write command enables or disables the presentation mode of <view> and selects the preferred <line>.
Parameter Description
Controls the presentation mode of the URC "^SALS" which indicates the line number used by an incoming call:
0
(&F)
Disables indication of the called line
1 Enables indication of the called line
Selects the line to be used for outgoing calls.
[1] ALS Line 1
2 ALS Line 2
Notes
• The selected <line> will be saved at non-volatile Flash memory and thus retained after Power Down.
• The
<line> will be reset by AT&F and ATZ and afterwards saved at non-volatile memory too.
• The
<view> will be reset after Power Down as well as by ATZ or AT&F.
• If a non ALS SIM is inserted, the
<line> will be reset to line 1 as well.
Example
<view>
(num)
<line>
(num)
AT^SALS=1,1
Line 1 has been selected for outgoing calls. "^SALS" URC is enabled.
RING
You receive a notification that you have an incoming call on line 2.
^SALS: 2
To Next Page
Loading...
Need help?
General
