TC35i AT Command Set
11.8 AT+CMGW
s
m
obil
e
TC35i_ATC_V02.07 Page 289 of 439 1/30/04
Confidential / Released
Command Description
The execute and write commands transmit SMS (either SMS-DELIVER or SMS-SUBMIT) from TE to memory
storage
<mem2>. Memory location <index> of the stored message is returned. Message status will be set to
'stored unsent' unless otherwise given in parameter
<stat>.
After invoking the execute or write command wait for the prompt ">" and then start to write the message. To save
the message simply enter
<CTRL-Z>. After the prompt a timer will be started to observe the input.
To abort writing use
<ESC>. Abortion is acknowledged with "OK", though the message will not be saved.
Notes
• If writing fails, for example, if a message is too long, the result code depends on the current setting of the
AT^SM20 command:
If the
AT^SM20 <CmgwMode>=1 (factory default) any failure to send a message is responded with "OK". Users
should be aware, that despite the "OK" response, the message will not be written to the selected SMS stor-
age.
If the
AT^SM20 <CmgwMode> equals 0 any failure to write a message is responded with "ERROR".
• If writing fails due to timeout, then
AT^SM20 <CmgwMode>=1 causes "+CMS ERROR: Unknown error" to be returned;
AT^SM20 <CmgwMode>=0 causes "+CMS ERROR: timer expired" to be returned.
• Note that some providers do not recognize an @ symbol used in a short message. A widely used alternative
is typing "*" as defined in GSM 03.40 (GPP TS 23.40).
• For baudrates lower than 19200 it is recommended to use the line termination character only (refer to
ATS3=
<n>, default <CR>) before entering the text or PDU. Use of the line termination character followed by the
response formating character (see
ATS4= <n>, default <LF>) may cause problems.
• SMS-COMMANDs and SMS-STATUS-REPORTs cannot be stored in text mode.
• All characters entered behind the ">" prompt will be recognized as GSM characters. For example, "Back-
space" (ASCII character 8) does not delete a character, but will be inserted into the short message as an addi-
tional physical character. As a result, the character you wanted to delete still appears in the text, plus the GSM
code equivalent of the Backspace key.
• In text mode, the maximum length of an SMS depends on the used coding scheme: It is 160 characters if the
7 bit GSM coding scheme is used, and 140 characters according to the 8 bit GSM coding scheme.
• The length of 8-bit data coded short messages has to be greater than 0.
To Next Page
Loading...
Need help?
General
