Siemens TC35i Terminal User Manual

TC35i AT Command Set
12.2 AT^SCKS
s
m obil e
TC35i_ATC_V02.07 Page 330 of 439 1/30/04
Confidential / Released
The write command enables or disables the presentation of URCs to report whether or not the SIM card is con-
nected.
If the ME is powered down or reset (
AT+CFUN or AT^SMSO) the current presentation mode setting <mode> will
not be retained. Therefore the setting
<mode>=1 needs to be restored after power on the TC35i or may be saved
in the user profile (
AT&W).
Parameter Description
0
(&F)
Suppress unsolicited result codes
1 Output unsolicited result codes
0 Card holder tray removed or SIM connection error
1 SIM inserted(refer to note)
Note
• <SimStatus> reflects the status of the SIM and the card holder tray. Therefore if an empty SIM card tray is
inserted, two URCs will be presented, indicating the status 1 followed by 0, i.e. a SIM is inserted into the card
holder tray but no SIM connection could be established.
Example
Now, after inserting an empty card tray the following URCs appear:
<mode>
(num)(&W)(&V)
<SimStatus>
(num)(&V)
AT^SCKS=1 Activates the presentation of unsolicited result codes
OK
^SCKS: 1 Tray connected
^SCKS: 0 No SIM card found

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English