TC35i AT Command Set
14.4 AT+CPBW
s
m
obil
e
TC35i_ATC_V02.07 Page 350 of 439 1/30/04
Confidential / Released
Parameter Description
Location number within phonebook memory. The supported range is given whith the test command response.
Phone number with format specified by
<type>. Parameter must be present, although it may be an empty
string. However, alphabetic characters are not permitted.
<number> may contain printable non-alphabetic characters of the standard GSM alphabet as dialstring modifi-
ers, including "*", "#" or "+". However, if
<number> contains modifiers other than "*", "#" or "+" the following con-
straints shall be considered:
• If no
<type> was specified explicitly, all accepted modifiers from the GSM alphabet will be saved in the num-
ber string.
<type> will be set to 209 (ASCII). However, limitations as listed below for <type> 209 apply.
•A
<number> saved with <type>=209 requires double memory. In order to fit into a standard location, the
number needs to be reduced to a maximum length of
<nlength>/2, including all digits and dial string modi-
fiers. Extended locations may be used as stated below for
<nlength>.
Type of address octet
If
<type> is specified as 129 or 145, any non-digit characters other than "*", "#", or "+" will be removed from the
number string. If the number string contains such characters, they can be saved with the number string by using
<type> 209, see below.
145 dialling string
<number> includes international access code character '+'
209 dialling string
<number> contains printable non-alphabetic non-digit charac-
ters that should be saved with the number string. Remarks as under parameter
<number> apply. For phonebook entries with this type, dialling from phone-
book with
ATD><mem><n> is not possible.
129 otherwise
Text assigned to the phone number. The maximum length for this parameter is given in test command response
<tlength>. When using an ASCII terminal, characters which are coded differently in ASCII and GSM have to
be entered via escape sequences as described in chapter
Supported character sets.
Max. location for the currently selected storage. For phonebooks located on SIM, this value may vary between
SIM cards. See
AT+CPBS for typical values.
Max. length of phone number for "normal" locations. - Depending on the storage, a limited number of locations
with extended memory is available per phonebook. These locations allow storing numbers with twice the stan-
dard length, which is 2*
<nlength> digits for normal numbers, but only <nlength> digits for numbers saved
with parameter
<type>= 209. If all extended locations of the selected phonebook are used up, then any attempt
to write a number which requires extended memory will be denied with CME ERROR 260: INVALID DIAL
STRING.
<location>
(num)
<number>
(str)
<type>
(num)
<text>
(str)(+CSCS)
<maxloc>
(num)
<nlength>
(num)
To Next Page
Loading...
Need help?
General
