TC35i AT Command Set
15.18 AT^SRTC
s
m
obil
e
TC35i_ATC_V02.07 Page 393 of 439 1/30/04
Confidential / Released
The execute command is intended for testing. It starts to play a melody from the audio output currently selected
with the
AT^SNFS command. To deactivate test playback use AT^SRTC again.
During test playback, you can enter the Write command to select another melody and adjust the volume. Also,
you can enter the read command to check the type and volume of the current ring tone, and to view the status
of playback (on / off). The test ringing signal cannot be activated when an MTC is ringing (ERROR).
Selecting
<volume>=0 during the test, immediately stops playback. After this, ring tones will be muted until you
change
<volume> using the write command.
The write command chooses the type and volume of ring tones for the selected event. The settings can be
changed no matter whether or not the ME is ringing. The selected type and volume are saved in the non-volatile
Flash memory and, thus, are retained after Power Down. An exception is
<type>=0, that can be entered to
quickly mute the tone or melody currently played to indicate an event.
<type>=0 only stops immediately the
audible ring tone, but does not terminate the URC that indicates the event (for example RING). No permanent
settings are changed or saved.
Before first using ring tones:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory set-
ting is
AT^SRTC=3,0,3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the write
command and simply change the volume. After applying a firmware update the volume and type selected before
the firmware update will be preserved.
Parameter Description
Type of ring tone. You have a choice of 7 different ring tones and melodies. All will be played from the audio
output selected with the
AT^SNFS command. <type>=0 is only intended for muting.
0 Mutes the currently played tone immediately.
1 Sequence 1
2 Sequence 2
3
(D)
Sequence 3
4 Sequence 4
5 Sequence 5
6 Sequence 6
7 Sequence 7
Volume of ring tone, varies from low to high
0
(D)
Mute
1Very low
2 Identical with 1
3 Low
4 Identical with 3
5 Middle
6 Identical with 5
7High
<type>
(num)
<volume>
(num)
To Next Page
Loading...
Need help?
General
