TC35i AT Command Set
16.5 AT^SCTM
s
m
obil
e
TC35i_ATC_V02.07 Page 405 of 439 1/30/04
Confidential / Released
Unsolicited Result Codes
URC 1
URCs will be automatically sent to the TA when the temperature reaches or exceeds the critical level, or when
it is back to normal.
^SCTM_A: <m>
for battery temperature
URC 2
^SCTM_B: <m>
for module (board) temperature
Command Description
The read command returns the following parameters:
• the URC presentation mode
• information about the current temperature range of the module
Please note that the Read command does not indicate the temperature range of the battery. This value can
only be reported by an Unsolicited Result Code.
• The board temperature in Celsius if parameter
<p>=1.
Select
<n> to enable or disable the presentation of the URCs. Please note that the setting will not be stored upon
Power Down, i.e. after restart or reset, the default
<n>=0 will be restored. To benefit from the URCs <n>=1 needs
to be selected every time you reboot the GSM engine.
Parameter Description
0
(&F)
Presentation of URCs is disabled (except for <m> equal to -2 or +2).
1 Presentation of URCs is enabled.
-2 Below lowest temperature limit (causes immediate switch-off)
-1 Below low temperature alert limit
0 Normal operating temperature
1 Above upper temperature alert limit
2 Above uppermost temperature limit (causes immediate switch-off)
0
(&F)
Suppress output of <temp> in test and read command.
1 Output
<temp> in test and read command.
Board temperature in Celsius. Is comprised between the lowest temperature limit and the uppermost tempera-
ture limit.
<n>
(num)
<m>
(num)
<p>
(num)
<temp>
(num)
To Next Page
Loading...
Need help?
General
