Siemens TC35i Terminal User Manual

TC35i AT Command Set
2.14 AT^SCFG
s
m obil e
TC35i_ATC_V02.07 Page 54 of 439 1/30/04
Confidential / Released
Command Description
The read command returns a list of all supported parameter and their current values.
The write command allows to query a configuration parameter (if no value is entered) or to set its value(s).
Input of parameter names is always coded in GSM character set, parameter values are expected to be given as
specified via
AT+CSCS.
The following error codes may be responded:
• "+CME ERROR: operation temporary not allowed" ... change of parameter value(s) temporarily not allowed
• "+CME ERROR: invalid index" ... invalid parameter name or invalid value(s).
• "+CME ERROR: invalid characters in text string" ... a character set conversion of parameter value(s) failed
• "+CME ERROR: operation not allowed" ... change of parameter value(s) not allowed
• "+CME ERROR: unknown" ... other errors
Parameter Description
AutoExec Command
This parameter specifies the AT command action type.
If the action type is set to '0', parameters following
<AutoExecIndex> will be ignored and all values at the given
index are restored to their default values.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
“0“ Disable execution of AT command at given index.
“1“ Enable execution of AT command at given index. Not allowed for
<AutoEx-
ecType>
=0 (DTR line activation) while multiplex mode is active, refer to
AT+CMUX.
AutoExec Command Status
This parameter shows the current AT command status.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
“0“ Execution of related AT command is disabled.
“1“ Execution of related AT command is enabled.
AutoExec Event Type
This parameter specifies the kind of event that may be configured to automatically launch an AT command.
Value will be saved while switching off the TC35i via AT commands (e.g.
AT+CFUN or AT^SMSO) and restored
on next power up.
“0“ ASC0 DTR line activation (OFF-ON transition).
“1“ Time span specified with
<AutoExecPeriod> expires.
<AutoExecCmd>
(str)(+CSCS)
<AutoExecState>
(str)(+CSCS)
<AutoExecType>
(str)(+CSCS)

Siemens TC35i Terminal Specifications

General

Brand	Siemens
Model	TC35i Terminal
Category	Modem
Language	English