Siemens TXP-CLC - Page 185

TXP-CLC Course
11
1
2
Once in the target diagram, we need to close the connection
from the source diagram that was just sent here. Follow these
steps:
1
.
With the mouse in the input side of
the page press and hold the middle
mouse button and select “create
connection” from the window
.
positive signal
negative signal
action line
flow line
4.
In the next mask all signals that have been sent to
this diagram and not yet closed will appear. Select
the desired signal from the list and click on
“accept”
Paste
Refresh
Create connection
Go up
Create connection
2.
Drag the mouse to the desired input on
the destination function block then click
the left mouse button
3
3.
In the next mask we could type in the KKS
of the source diagram, but since it was
already sent here all we need do is press
“select”
4
5.
The following mask shows all the signal
information for this particular signal
(both source and destination). Click on
“ok” and the signal will connect.
Once this is accomplished, the signal
can be selected with the left mouse
button and with the middle mouse
button select “Follow signal” to follow
the signal to it’s source.
5
Training Center