SIGLENT SDS1102CML - Required Tools; Disassembly Procedures

SIGLENT
SDS1000CML/CNL/DL Service Manual 29
Table 5-1 List of modules
Number of Module Module
1 Front-Panel Knobs
2 Rear Panel
3 Rear Metal Cover
4 Top Metal Cover
5 Power Supply Module
6 Metal Shelf
7 Main Board Module
8 Fan Module
9 Display Module
10 Keypad Module
Required Tools
Use these tools to remove or replace the modules in the oscilloscope:
 T6, T10 and T20 TORX drivers
 5/8- inch and 9/32- inch socket drivers
 Flat head screw driver
Disassembly Procedures
This section describes how to remove and install the modules listed above in
the oscilloscope in detail. Complete disassembly will be best achieved through
the following operating steps.