SIGLENT SDS1102CML - Default Setup

SIGLENT
SDS1000CML/CNL/DL Service Manual 7
Press the Power button located at the top of the oscilloscope and some keys
will be lighted for about 6 seconds simultaneously until the boot screen
appears. Then the oscilloscope begins to perform its power-on tests
automatically, after that you can press the DEFAULT SETUP button to recall
the factory default settings.
Default Setup
When you press DEFAULT SETUP button, the oscilloscope displays
waveforms of CH1 and removes waveforms of CH2.
Table 2-1 Default settings
Menu or System Option Default setting
Coupling DC
Bandwidth limit Off
Volts/Div Coarse
Probe 1x
Invert Off
CH1/CH2
Filter Off
Operation
+
CH1
Hanning
1X
dBVrms
MATH
FFT Operation
Source
Window
FFT Zoom
Scale
Display
Split
Delay Off
Sec/Div 500us
Position 0s
HORIZONTAL
Window Zone 50us
Type Off
Source CH1
Voltage +/-3.2 divisions
CURSOR
Time +/-8 divisions
Acquisition Sampling
Sin x /x Sin x
ACQUIRE
Mode Real Time
Type Vectors
Persistence Off
Intensity 60%
Brightness 40%
Format YT
DISPLAY
Menu Display Infinite
Type Setups
Save to Device SAVE/RECALL
Setup No.1