StreamCaster 4000 series MIMO Radio User Manual 9/2/20
10017C000 Silvus Technologies Confidential Page
• Beamforming (SC4200/SC4400/IVAS): Enable or disable TX Beamforming (Up to 2X increase in
range when enabled)
• Transmit Channels: Allows user to Enable or Disable each channel on the radio for TX.
• Receive Channels: Allows user to Enable or Disable each channel on the radio for RX.
• Radio Mode: Switch between Network mode and PHY Diagnostics. If the value equals 0, it is in
Network mode; if the value equals 1, it is in PHY Diagnostics. PHY Diagnostics mode is only relevant
for users who wish to run diagnostic tests on the radio.
• Apply: Applies the new values but does not save them to flash.
• Save and Apply: Save the new values to flash and apply.
To Next Page
