StreamCaster 4000 series MIMO Radio User Manual 9/2/20
10017C000 Silvus Technologies Confidential Page
5.1.3 Bidirectional Amplifier (not available on IVAS)
Figure 34 Bidirectional Amplifier (BDA) Configuration Page
The BDA Support page is used to configure the radio to work with an external bi-directional amplifier.
These settings should be configured before connecting the amplifier to the radio.
• BDA Mode: You can enable or disable the BDA mode here.
Basic Settings:
• BDA Gains for Channels 1-4: Enter the gain (dB) for the power amplifier connected to each
channel of the radio. This is sometimes labeled as Tx gains.
• LNA Gains for Channels 1-4: Enter the gain (dB) for the LNA connected to each channel of the
radio. This is sometimes labeled as Rx gains.
• Maximum BDA Output Power Per Channel (dBm): Enter the maximum output power for each
PA. If the dBm is not listed, you should be able to calculate this from the Watt rating of the amp.
• Apply: Apply the new values but does not save them to flash.
• Save and Apply: Save the new values to flash and apply.
To Next Page
Loading...
