2-1
Selective signaling replaces the system’s general alarm NAC operation – which
activates all NACs in response to any alarm condition – with selective NAC
control. This type of control allows you to program the system so that only
specific NACs respond to specific initiating devices.
Refer to the following page for specific information on a topic.
Topic See Page #
Selective Signaling by Floor 2-2
Selective Signaling by Area 2-7
Selective Signaling by Fire Floor, Floor Above, and
Floor Below
2-12
Selective Bypass of NAC/Relay Circuits 2-17
Selective Activation of Single Station Devices 2-21
Chapter 2
Selective Signaling Applications
Overview
In this Chapter
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
