5. Press the <Fl> key (above the alphanumeric display). The display shows the following message.
I
Enter a Passcode followed by <ENTER>
6. Enter the passcode (up to 10 numbers). Press the <ENTER> key on the ENTRY keypad. For security
reasons, an “X” is displayed for each digit of your passcode, as shown below.
I
Enter a Passcode followed by <ENTER>
xxx
If the passcode is correct, the following message is shown.
I
Enter a Passcode followed by <ENTER>
ACCESS GRANTED
After a brief pause, the display shows the granted access level, such as the level 2 access message shown
below.
I
Fl=Login F2=Logout
CURRENT ACCESS LEVEL = 2
I
7. Press the <CLR> key twice. The display shows system status, as shown below.
SYSTEM IS NORMAL
08:24:44 MON 04-APR-94
LOG OUT PROCEDURE
IMPORTANT
FAILURE TO LOG OUT ALLOWS UNAUTHORIZED PERSONNEL ACCESS TO THE VARIOUS
PASSCODE PROTECTED FUNCTIONS. IF NO KEYPAD ACTIVITY IS DETECTED FOR TEN MINUTES,
THE SYSTEM WILL RETURN TO LEVEL 1 ACCESS.
Perform the following procedure to Log Out and return the operator access level to LEVEL 1 status.
4
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
