WARNING
If the zone is still in alarm, a WARNING is displayed which tells you that the system will sound an
alarm if the timer (60 seconds) times out. TO ABORT THE ENABLE, PRESS THE <DISABLE> KEY. If
an alarm condition exists, the following is shown on the alphanumeric display.
I
**WARNING** Press <DISABLE> to abort
1010 will ALARM in 60 seconds
IF THE ABOVE WARNING IS SHOWN CN the ALPHANUMERIC DISPLAY, PRESS the <DISABLE> OR
AN <ACK> KEY. FAILURE TO ABORT THE ENABLE, WILL CAUSE AN ALARM CONDITION.
If the enable process is successful, the following message is shown on the alphanumeric display.
I
ENABLE COMPLETED
I
4. Repeat steps 1 through 3 above to enable required points.
5. Press the <CLR> key to exit. This will allow the panel to show the Time and Date.
WHAT TO DO IN CASE OF SYSTEM MALFUNCTION
CALL YOUR LOCAL SIMPLEX BRANCH OFFICE, WHICH IS LISTED IN THE YELLOW PAGES, FOR ALL
MALFUNCTIONS, OR IF YOU WOULD LIKE A QUALIFIED SIMPLEX TECHNICIAN TO ASSIST YOU WITH
INSTALLATION, TESTING, AND TROUBLESHOOTING THE SYSTEM.
61
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
