Simplex 4100 Service Instructions

NOTES:
1. Arrows indicate direction of
information flow.
l Two-way arrows (<:<-
>>I
indicate information flows
in both directions.
2. Plug and terminal block names
are listed on the following pages.
LCD
Keypad
3. Pll, P12 and P13 available to
power additional signal circuits.
Pl
P3
Master Display Board
P2
4. This harness is unsupervised.
Master
ansion
‘“IP q
cc- 22 TO P2, tirst ex
Cotnt~olJer
board (if use
J
-am ”
>> To local annunciator
Master r
Motherl
P3
p1 l--v
Master Signal Power
(See Note 4)
_ _
J
TB4
l-
I
I II II
II II II II I ,
_ Pl P2 P3 P4 P5 P6 P7
P8
PlO
-*a
Standby Batteries (if used) e<- P9
Master Power Supply
Pll
t
1
>> Two Auxiliary Relay Circuit Outputs
- See
** Two Feedback Circuit Inputs
P14
P12
_ N:te
*> Two Signal Circuit Outputs
Pl5
P13
-<< Eight Zone Circuit Inputs
- P16 P17
->a City Connection Output
-->> System Trouble Output
120 VAC Input (Operating Power) s>
120 VAC Input (Supervisory Power [if used]) 5,
/
Figure 1
Graphic Representation of Basic 4100 Fire Alarm System
2
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes