Simplex 4100 Service Instructions

J
SWI-2 through SW1 -8 = Card address select switches (SW1 -2 = MSB, SW1 -8 = LSB).
LED1
SW1
LED2
LED3 LED4
1
RUI ASSY 565-217A 2
Figure 30
Remote Unit Interface Card
DECODER MODULE (565270)
Features and Functions
Provide an interface to mechanical and electronic coded initiating devices.
Component Locations and Functions (Figure 31)
LED1
Lights during initialization until communications are
established with the 4100 Master and whenever
communications are lost with the Master.
16 character x 2 line LCD that is used in programming the Decoder Module. Potentiometer Rl is used to adjust the
LCD contrast for best viewing.
Switches
SW1
Up = PROGRAM mode (allows codes of the stations connected to the Decoder to be entered.
While in this mode, alarm reporting is disabled, and a “MAPNET Communications Failure”
message is indicated at the 4100 front panel)
Down = NORMAL mode (enables Alarm Decoding and reporting)
SW2-SW7 Push button switches which are used in programming the Decoder
SW2 = Selects programming mode
SW3 = Move Left
50
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes