Simplex 4100 Service Instructions

Table 1
Battery Test Requirements
Amp Hr. Total
Read Battery
Battery
Total Current
Simplex Voltage
Minimum
%ii
Voltage
Circuit
and Power
Part Number (unF;;yd)
Voltage
Resistance
. Req’d
.
5.2 12v 2 Ohms 6A, 72W
380-031 and 382-090
60 Seconds 11.2v
6.2 12v 2 Ohms 6A, 72W (in parallel) 60 Seconds 11.2v
8 12v 1.5 Ohms 8A, 96W
382-090
60 Seconds 11.2v
10
12v
1.5 Ohms 8A, 96W
(2 in parallel)
60 Seconds
11.2v
18 12v 0.75 Ohms 16A, 196W 60 Seconds 11.2v
20 12v 0.75 Ohms 16A, 196W 60 Seconds 11.2v
33 12v 0.75 Ohms 16A, 196W 4 Minutes 11.2v
382-090
12v
(4 in parallel)
50 (;eI;;y;, 0.75 Ohms 16A, 196W 60 Minutes 11.7v
series)
110 12v 0.75 Ohms 16A, 196W 60 Mlnutes 11.9v
Table 2
Battery Disposition Guide
Battery
Capacity
Voltage
Reading
/ 11.2Vormore 1
5.2thru33Ah / 10.8Vto ll.lV I
10.7V or less
I 11.7Vormore /
50 Ah
/ 11.2Vor11.6V I
ll.lV or less
1 11.9Vor more /
X
I I I
110 Ah
1 11.4Vto 11.8V 1
11.3V or less
NOTE 1: Discard battery if battery has been in service for four or more years (dispose of properly).
NOTE 2: Dispose of properly.
86
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes