Simplex 4100 Service Instructions

Identical in function to Switch SW1 in an El-Zone Monitor Card.
JumDers
NOTE: The following jumpers are zero-ohm resistors.
CARD TYPE
JWI
1 Channel, 2 Points, Style Y OUT
1 Channel, 2 Points, Style Z IN
1 Channel, 6 Points, Style Y OUT
1 Channel, 6 Points, Style Z IN
2 Channel, 4 Points, Style Y OUT
2 Channel, 4 Points, Style Z IN
4 Channel, 2 Points, Style Y OUT
4 Channel, 2 Points, Style Z IN
JW2 / JW3
OUT IN
OUT IN
OUT OUT
OUT OUT
IN N/A
OUT N/A
IN N/A
IN N/A
JW4
OUT
OUT
OUT
OUT
N/A
N/A
N/A
N/A
JW5 JW6 JW7
N/A
N/A N/A
N/A N/A N/A
N/A
N/A N/A
“”
N/A 1 OUT 1 OUT 1
NOTE: A Style Z signal card can be converted to Style Y operation by changing its jumper settings, but not vice
versa.
Connectors
NOTE: See the 841-784 Field Wiring Diagram.
Pl = Fits into Socket J2 on the motherboard.
P2, P3, P4 and P5 = 6-pin “24VDC signal power,” “phone input” or “audio input” connectors, each capable of
accommodating two of the following harnesses.
l For 24VDC signal power = 733-523 harness (49”)
733-578 harness (24”)
l For audio or phone inputs
i
733-579 harness (43”)
733-580 harness (76”)
l Input harnesses must connect to pins 1, 2 and 3. Output harnesses (if used) must connect to pins 4, 5 and 6.
IMPORTANT: Check harness connections before applying power.
AN IMPROPER CONNECTION MAY CAUSE SYSTEM DAMAGE!
31
firealarmresources.com

Simplex 4100 Specifications

General

Type	Fire Alarm Control Panel
Manufacturer	Simplex
Model	4100
Network Capability	Yes
Addressable	Yes
Power Supply	120/240 VAC, 50/60 Hz
Display	LCD
Annunciator Support	Yes
Battery Backup	Yes
Releasing Capability	Yes
Max Devices	Depends on configuration
Max Notification Appliance Circuits (NAC)	Varies with configuration
Max Releasing Circuits	Varies with configuration
Max Remote Annunciators	Varies with configuration
Communication Ports	Multiple
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
NAC Outputs	4 (expandable)
Networking	Yes