Operation
20222121A 13
After approximately 5
seconds, the following
message is displayed.
The system is now operative and the unit that was turned on will
show the Standby mode display. Other units in a multistation
system will display "Inactive" and/or
depending on model.
Control is transferred to any single unit by pressing its’ STBY
button.
A long press (2-3 sec.) on the STBY button switches the system
OFF and during this time, the alarm will sound.
Note ! In an emergency, it is possible, on a multistation system, to turn
OFF the autopilot system at any control unit by pressing the
STBY button for 2-3 seconds.
STBY mode is the mode that is used when steering the boat at
the helm.
Display information:
− Standby mode
− Current heading 345°M
− Compass source: Rate
compass
− Rudder angle 00°.
Note !
Whenever you take manual
control of the steering by
means of the helm
irrespective of the autopilot
mode, the autopilot will go
to Standby. The “S” in the
display is replaced by a
dash to indicate that
steering is from the helm.
To Next Page
Loading...
Need help?
General
