Simrad AP16 Autopilot
74 20222121A
Global SimNet reset
Resets the entire SimNet setup in the
Simrad Group and initiates a new
automatic interface setup. See
chapter 4.1.
Master Reset
Note ! A Master Reset is part of the final test at the factory, which will
reset the memories to factory settings. Unless you need to clear
all stored values during the installation setup procedure, you
should not perform a Master Reset.
The Master Reset needs a double
confirmation to prevent an
accidental reset. To perform a
Master Reset, press the STBD 10
button and observe the display;
then press the PORT 10 button.
The display will then read: “Master
Reset confirmed”.
Unless you have made a Master
Reset, exit the Installation Menu by
pressing STBY to return to normal
AP16 operation.
In the event a Master Reset has been made, refer to chapter 0.
Final sea trial
After having completed all settings in the Installation Menu, take
the boat out and perform a final sea trial in open waters at a safe
distance from other traffic. .
− Steer the boat on all cardinal headings in AUTO mode.
− Start with low and medium speeds to get familiar with the
response from the AP16.
− Try the effect of LO and HI parameter settings.
− If the hardware for automatic HI/LO parameter selection is
connected and configured, verify that the HI/LO transition is
occurring, and the HI/LO parameters are changing after the
To Next Page
Loading...
Need help?
General
