CE33 Echosounder operation Chapter 7-9
7.8 Echosounder setup
The Echosounder setup display mainly consist of general settings,
but also applies to a specific frequency where stated. The CE33 fea-
tures semi dual transceiver transmitting at 50 and 200 kHz.
MENU
Call up the menu bar, and...
5,7
activate Echosounder setup display
Use the cursor key to move cursor around in the display
+/-
Select new values by means of the +/- keys
ENT
Confirm changes, or...
MENU
Abandon changes and exit display
Transducer - select transmitter frequency 50kHz or 200kHz. Insert
the depth (position) of the transducer below surface.
Display can show: DEPTH BELOW KEEL / SURFACE / TRANS-
DUCER.
Data on NMEA-out from - select the frequency you wish to use for
To Next Page
Loading...
