CE33 Waypoint / route menu Chapter 5-9
5.4 Lines stored in the memory
The line list will keep a record of all the saved lines in the system. It
will provide information on number of line sections in line etc.
‘Lines’ are used for defining a certain area on the chart e.g. a fishing
ground, a shipwreck, large rocks, restricted areas etc., or definging a
channel to sail through narrow passages, making your own coast line
or for whatever reason you could use a drawing on the chart.
To draw new lines you need a chart in the active window, place the
cursor where you wish to start the line, and press [PLOT]. Then
follow the instructions in the info windows. Refer to section 3.3.9.
Lines can also be edited directly on the chart via info windows, refer
to section 3.3.4 and 3.3.5.
MENU
Call up the menu bar, and...
3,4
load line list display
- only plotted lines saved in the memory can be called forward.
This display
indicates
how many
line sections
are used for
the drawing.
+/-
Toggle through the stored lines with the +/- keys, or...
Leaf through the line points by moving cursor up/down
ENT
Call up the Edit line display - if you wish to make changes.
To Next Page
Loading...
Need help?
General
